GANRO TR-120S TILTING CNC ROTARY TABLE

GANRO TR-120S TILTING CNC ROTARY TABLE

The latest TR-S (S = shorter for use on VMC’s) tilting range from Ganro, with major developments over earlier models with major increases in speed, with a high power pneumatic clamping system.

The Tsudakoma TR-120 is a heavy duty small CNC rotary table tilting device, ideally suited to small drilling and tapping centres or for small VMC machines, with a faceplate diameter of 120mm with options to accept a 130mm or 150mm faceplate or can accept a standard or power chuck.

The unit has a 30mm spindle bore directly through the table and a has a centre height of 160mm in the vertical position (90 degrees) and 212mm in the horizontal position (0 degrees) with faceplate.

This device is around 570mm in overall width subject to motor selection which suits a wide range of machine tool bed widths and an overall height of 265mm. The unit has a standard tilting range of -15 to + 115 degrees.

An excellent carrying capacity of 30kg through the whole tilting range and 60kg horizontally or between centres and speeds of up to 27.7rpm in the rotary axis and 22.2rpm in tilt dependent on motor selection. (Based on a 2,000rpm motor)

Net weight of this device is 170kg.

The GANRO TR-120S CNC rotary tilting table without motors, can be prepared to suit any interface at additional cost (see our interface listings for details and costs for “external interface” (motor, switch, cable and connector requirements if you already have a “4th / 5th axis interface” in the machine) and machine interface costs (if you do not have the additional axes fitted).

Rotary axis motor is mounted to the right hand side on this device and may restrict the Y axis capability in certain circumstances, the tilt axis motor is mounted in a rear facing direction on the far side of the device and should not have any bearing on traverses.

This range of GANRO devices come with dual lead worm and wheel, which means that backlash adjustment is simple.

GANRO is a leading class manufacturer from Taiwan and in our experience build a very fine device with a very long service life, probably greater than those we have experienced from other Taiwanese makers.

GANRO products carry a standard one year parts and labour warranty and have a full working partnership with CNCROTARY.COM, who provide a second year completely free.

This device may take from 2 to 3 weeks to configure as required.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



×
×
×
×
×
×
×
$(document).ready(function() { $('#slideshow').nivoSlider({ pauseTime:2000 }); });